Siemens 5WY19 PCB Components
Front Side
1. Infineon C167CS-LM CPU
16-Bit Single-Chip Microcontroller C166 Family
25 Mhz Operating Frequency
| Chip Markings |
|---|
| Infineon
SAK-C167CS-LM |
2. AMD AM29F400BB Flash
4 Megabit (512 K x 8-Bit/256 K x 16-Bit)
CMOS 5.0 Volt-only Boot Sector Flash Memory
| Chip Markings |
|---|
| AM29F400BB
-55SEO 0504GBA N |
3. Crystal
Generic 8.000000MHz Crystal
| Chip Markings |
|---|
| 0502 |
4. ST ATM38E-BD8035
Octal Channel Low-Side Switch.
| Chip Markings |
|---|
| 446776
8995L0453 |
5. Motorola TY94085DH
The TY94085DH is a 20-pin SOP (Small Outline Package) integrated circuit from Motorola.
It is used in a variety of applications such as motor control, power management, and data acquisition.
| Chip Markings |
|---|
| ATM37 1.1
94.67.13 KBK0502 |
6. Motorola TY94085DH
The TY94085DH is a 20-pin SOP (Small Outline Package) integrated circuit from Motorola.
It is used in a variety of applications such as motor control, power management, and data acquisition.
| Chip Markings |
|---|
| ATM37 1.1
94.67.13 KBK0502 |
7. OnSemi EcoSpark Ignition IGBT
500 mJ, 360 V, N−Channel Ignition IGBT
| Chip Markings |
|---|
| N419AF V5036S |
8. OnSemi EcoSpark Ignition IGBT
500 mJ, 360 V, N−Channel Ignition IGBT
| Chip Markings |
|---|
| N419AF V5036S |
9. Texas Instruments 51DLEKT (Knock Sensor Interface)
The TPIC8101 is a dual-channel signal processing IC for detection of premature detonation in combustion engine. The two sensor channels are selectable through the SPI bus.
| Chip Markings |
|---|
| TP1C8101DW |
10. Amis ATM46C3 (Siemens Rotax ECU Driver)
| Chip Markings |
|---|
| Siemens
0504TAK SDIA ATM46C3 966781 |
11. Nexperia 74HC32D (NXP)
The 74HC32D is a quad 2-input OR gate. Inputs include clamp diodes. This enables the use of current limiting resistors to interface inputs to voltages in excess of VCC.
| Chip Markings |
|---|
| AP052 07
UnN0451D |
12. Nexperia 74HC08D (NXP)
The 74HC08D is a quad 2-input AND gate. Inputs include clamp diodes. This enables the use of current limiting resistors to interface inputs to voltages in excess of VCC.
| Chip Markings |
|---|
| AP236 14
UnN0452E |
13. Infineon A2C33648 (Triple Voltage Regulator)
The A2C33648 is a monolithic integrated very low-drop triple voltage regulator.
The output supplies loads up to 450 mA and the additional tracked outputs can provide up to 50 mA and 100 mA.
| Chip Markings |
|---|
| 0502
ATIC17 E1 |
14. ST ATM39B-556757 (CMOS Gate)
The ATMEL ATM39B-556757 is a ST Microelectronics CMOS logic chip. It is a quad single gate device in a 20-Pin SOP package. Description: The ATM39B-556757 is a Quad Single Gate(QSG) with non-inverting logic. This device provides four independently controlled single gates with a power dissipation of 5.6mW per gate. The device is designed to operate with a supply voltage of 3V to 5.5V. Features: Low power consumption Maximum sink current of 8mA Maximum switching speed up to 16V/ns Low input capacitance High output drive current Latch-up protection ESD protection Applications: High-speed logic circuits Clock and data separators Programmable logic applications Logic switching applications Analog multiplexers/demultiplexers.
| Chip Markings |
|---|
| 990MT VB 99
507 MYS |
15. Nexperia (NXP) 74HCT574D - SRAM?
The 74HC574D is a high speed CMOS OCTAL FLIP-FLOP with 3-STATE OUTPUT fabricated with silicon gate C2MOS technology.
| Chip Markings |
|---|
| AO192 10
UnG0450G |
16. Nexperia (NXP) A82C250 - CAN Bus
| Chip Markings |
|---|
| 4R0R8
n6504 |
The PC A82C250 is the interface between a CAN protocol controller and the physical bus.
The device provides differential transmit capability to the bus and differential receive capability to the CAN controller.
- Fully compatible with the “ISO 11898” standard
- High speed (up to 1 MBd)
Back Side
